I like to share with RC airplane fan that facing with rudder problem . Often it happen after the RC airplane got crashed.
Here the example of RC Airplane Mustang with rudder problem.
The Rudder "piece holder" strip off and nearly to tear. You have no " piece holder" to replace it.
Take the unused Floppy disk.
1) break the cover.
2) remove the magnetic film media,& cut it to get a small square piece, equivalent size with spoil rudder
"piece holder"
3) rub both magnetic film surface using pen eraser.
4) Apply the foam glue to that magnetic film and insert it properly into rudder "piece holder" position.
Now ,you had fixed the RC Airplane rudder problem.
Have Fun...
Sometime you need to keep your mobile phone in silent mode. Unfortunately the vibrator not work
Here are the tips that you can do to the vibrator function again, but you need to dismantle the mobile phone
Here are my friend mobile phone Sony Ericsson K530i for use in routine job. It 's not vibrate, only ringing.
Firstly,before you dismantle the mobile phone,you must ensure that all setting for vibrate are 'ON'.
Actually the basic function for vibrator are same for all mobile phone.
Using the multimeter , set value to X1 , set the positive (+) and negative (-) probe to the vibrator pin.
if the vibrator start to rotate, it's mean the vibrator are not spoil. try to clean the contact pin.
if the vibrator rotate in intermittent , give a little bit ointment to the vibrator, one drop of eg.WD-40.
or replace with new vibrator. You can buy it at nearest mobile phone repairing shop. Just pay for the part
cost. Save the Labour repairing cost. All the Best. Good Luck
daily tips & diy for you
